A machine which might dispense juice /water.
Precept
When air is flown to the closed bottle the strain within the bottle additionally will increase, as the opposite pipe is immersed within the liquid, the liquid flows towards gravity and is allotted. Supplies required.
Elements Required
The elements used for the challenge are as follows:
- MDF Boards
- Hinges
- Air pump motor *3
- Pneumatic Air Hose Pipe
- Wires
- Change
- Resistors 1k ohm
- 9V provide
Complete price of all of the elements ~ 1k INR
Circuit Diagram
Construct Make a field utilizing 5 items of MDF board 12inch *12 inch – 3.5 mm thickness
Use one other MDF of the above dimension and add a hinge in order that the field will be accessible from the highest
Drill 3 holes within the entrance for LED and one other 3 for push buttons
Solder wires to the three air pump motors and guarantee that the motor is giving an sufficient output of air
Take 3*750mL of juice / water bottles and drill 2 holes of two.5mm thickness every on it .
The motors must be mounted on the left and proper MDF’s so take measurement accordingly Take pneumatic air hose pipe and fasten it to the motor and the pipe should attain the bottle cap and go barely inside (shouldn’t submerge within the juice) . Do the identical with the opposite 2 motors
Make a allotting construction to make the design look extra skilled, the allotting pipe is contained in the construction.
Take some air pipes and put it within the different gap of the juice cap and this pipe should go fully down the juice bottle (submerge within the liquid). The identical needs to be completed for the opposite 2 methods.
Connect 2 motors to the left / proper MDF and one other to the proper / left MDF utilizing U Clamp suitable with the dimensions of the motor.
Further Particulars
Ensure the air pipes and the juice pipes are usually not fully bent at anywhere
Ensure the air pipe and the juice pipes don’t go up unnecessarily because it reduces the air strain and reduces the juice move
The juice stuffed within the bottle bottle needs to be round ¾ of the bottle capability (For 750mL bottle the juice loaded needs to be round 562.5mL for optimum efficiency)
The ultimate construct appears like this
Working
When the button is pressed , the air pump motor blows air by way of one of many pipes which fits to the bottle (not submerged in liquid) and the liquid is allotted from the opposite pipe (submerged within the liquid) and the liquid is channelled to the dispenser.
